The Pearl Vocal

The Pearl Vocal is designed for use in today`s modern improved quality P.A. systems as high-end vocal stage microphone.

The Pearl Vocal is specifically designed to be the ultimate condenser hand-held stage microphone. The newly developed medium-sized single diaphragm capsule provides high acoustic transparency and can handle sound pressure levels up to 144db without overload.

FRR is an optional unique reflection ring accessory which is used as a tool to slightly alter directional characteristics and frequency response by positioning at different points along the microphone body.

FRR Reflection Ring is a reflector disc which can be positioned at the head or anywhere along the body of the microphone to alter the polar pattern, frequency response and sensitivity. Positioning the FRR on the top produces a polar pattern closer to a half-sphere pattern with less coloration at different angles, less proximity effect and adds sensitivity to all except high frequencies. Positioning the FRR lower of The Pearl Vocal reflector alters low-frequency response and adds proximity effect. The FRR can also be used to separate the front and rear sides of the capsule and to reduce reflections and reverberation from reaching the capsule. FRR adds warmth, reduces acoustic feedback and protects against wrong handling of microphone. You can manipulate with sound using FRR.

The Pearl Vocal is specifically designed to be the ultimate condenser hand-held stage microphone. The newly developed medium-sized single diaphragm capsule provides high acoustic transparency and can handle sound pressure levels up to 144db without overload.

The Pearl Vocal introduce a new physical design with a rear-ported spherical head and a special narrow tapered form reflector to reduce internal resonances and reflections and optimize the unidirectional cardiod polar pattern.

A soft center band around the circumference of the head minimizes shock and handling noise. Rugged microphone construction and internal shockmounts effectively reduce stand rumble, outside infrasonic interference and mechanical shocks.

The internal phantom powered preamplifier's Class 'A' fully discrete transformerless circuit provides high output, flat audio response and ultra low distortion and noise. The output connectors are gold plated for best possible signal transfer. "The Pearl" is ready for noise-free handheld or stand use. A flexible stand holder is supplied with microphone. FRR is an optional unique reflection ring accessory which is used as a tool to slightly alter directional characteristics and frequency response by positioning at different points along the microphone body.

INCLUDED ACCESSORIES:

Plactic mic holder
 

OPTIONAL ACCESSORIES:

PSM - shockmount

GSM - shockmount

FRR - reflection ring

Specifications

Transducer type

True electrostatic

Operating principle

pressure gradient

Diaphragm's active diameter

21 mm (0.8”)

Frequency range

20 Hz to 20 kHz

Polar pattern

unidirectional - cardioid

 Electronics type

 Discrete solid state (SS)

Output impedance

50 ohms

Rated load impedance

1000 ohms

Suggested load impedance

>250 ohms

Sensitivity at 1000 Hz into 1000 ohms load

12 mV/Pa

S/N Ratio CCIR 468-3 weighted

70 dB

S/N Ratio DIN/IEC 651 A-weighted

80 dB-A

Equivalent noise level DIN/IEC A-weighted

14 dB-A

Maximum SPL for 0.5% THD at 1000 ohm load

144 dB

Dynamic range of the internal preamplifier

130 dB

Phantom powering voltage on pins #2 & #3 of XLR

+40 to +52 V on XLR pins #2 & #3relatively pin #1

Current consumption

<1,5 mA

Output connector

3-pin XLR male, gold plated contacts

Dimensions

207 mm x 42 mm / shaft 24 mm, 250 g